Engineering Calculators

Fire Sprinkler Hydraulic Calculation

Works the remote area back to the supply point in NFPA 13 units (psi, gpm, ft) and compares the demand against the water supply curve.

Reference data from NFPA 13, 2019 edition. Not a substitute for the standard, or for a licensed designer's review.

1. Project & hazard

For your own reference — not part of the calculation.

System type
Dry and preaction systems normally use a lower pipe C factor than a wet system (step 2).

Selecting a hazard fills in the design figures below. You can override any of them.

Before any quick-response reduction.

The area each sprinkler protects, applied to every sprinkler in step 4.

Added at the hose stream node (step 4). Enter 0 if no allowance applies.

NFPA 13 allows the design area to be reduced for quick-response sprinklers, by an amount that depends on the ceiling height, and gives none above a certain height. The reduction taken appears in the design basis below. The conditions attached to it are in the text of the standard and are not checked here — confirm them before relying on the reduced area.

Design basis

Working it out…

Your entries are kept in this browser only, so you can reload without losing them. They are never sent anywhere except to run the calculation.

No result yet — fill in the steps.

Fill in the steps to calculate